Daihatsu Micros P1642 Engine Trouble Code
What is Daihatsu Micros P1642?
Daihatsu Micros P1642 indicates potential catalytic converter failure. If completely failed, your vehicle may not run properly and fuel economy will suffer significantly. Average replacement cost is $2,000–$2,140. This repair requires professional service and should not be delayed.
P1642 on the Daihatsu Micros
The Daihatsu Micros ECU flash version prior to the 2.4.1 update has a known calibration bug that can generate spurious P1642 codes under hard deceleration. Verifying the ECU software version is always the first step before any mechanical diagnosis on this model.
Code Information
| Code Type: | OBD-II Powertrain (P) Trouble Code |
| System: | Powertrain |
| Vehicle: | Daihatsu Micros |
| Brand: | Daihatsu |
| Model: | Micros |
| Code: | P1642 |
P1642 Daihatsu Micros Symptoms
Check Engine Light
Illuminated Daihatsu Micros dashboard warning
Engine Stalling
Engine stops unexpectedly or misfires
Performance Issues
Reduced power or acceleration on the Daihatsu Micros
Starting Problems
Difficulty starting the engine
Poor Fuel Economy
Increased fuel consumption on the Daihatsu Micros
Increased Emissions
Failed emissions test due to P1642
P1642 Code Structure
Understanding what each digit means in the P1642 powertrain trouble code:
| P | 1 | 6 | 4 | 2 |
|---|---|---|---|---|
| Powertrain Code | Fuel And Air Metering | Fuel Temperature Sensor B Circuit Range/Performance | Injection Pump Fuel Metering Control 'B' High | Glow Plug/Heater Circuit 'A' Malfunction |
How to Fix Daihatsu Micros P1642
Diagnostic Steps:
The catalytic converter has oxygen sensors before and after it. When warm and in closed-loop mode, the upstream O2 sensor reading should fluctuate, while downstream should remain steady.
Repair Solution:
Gasoline engines use spark plugs to ignite fuel-air mixture. Proper timing ensures the explosion occurs when the piston is positioned correctly. Incorrect plug wire sequencing causes mistimed ignition, resulting in poor performance.
Technical Notes:
P1642 DTC specifically relates to camshaft timing. When cam timing is over-retarded, the check-engine light illuminates and this code sets. Verify VCT solenoid operation and check for contamination.
Daihatsu Micros P1642 Repair Cost
A fuel pressure regulator replacement on the Daihatsu Micros runs $180–$320 at a specialist. Fuel system work requires depressurisation procedures, so this is not typically a DIY job. Some workshops include a full fuel injector flow test (value: $80) at no extra charge.
P1642 Description
P1642 engine trouble code is related to Glow Plug/Heater Circuit 'A' Malfunction.
Main Cause
The primary reason for P1642 OBD-II Engine Trouble Code is: Fuel Temperature Sensor B Circuit Range/Performance.
Common P1642 Misdiagnosis on the Daihatsu Micros
Workshop technicians sometimes replace the entire ignition coil assembly on the Daihatsu Micros when P1642 accompanies a cylinder-specific misfire. In many cases, only the spark plug in the misfiring cylinder has fouled; a $8 plug replaces a $140 coil pack.
DIY Repair Guide: P1642 on Daihatsu Micros
The coolant temperature sensor on the Daihatsu Micros is a straightforward DIY item (difficulty 2/5). Have a drain tray ready for the small amount of coolant that spills when the sensor is removed. Top up the cooling system afterwards and check for air pockets.
Preventing P1642 on the Daihatsu Micros
For turbocharged Daihatsu Micros models, allowing the engine to idle for 60–90 seconds before shutdown after hard driving reduces turbocharger heat soak and prevents the coking of oil that blocks VVT galleries — a known secondary trigger of P1642.
Frequently Asked Questions — Daihatsu Micros P1642
A: Yes. Any stored fault code — including P1642 — will cause an automatic failure in most OBD-II based emissions tests. The code must be resolved and the vehicle must complete a full OBD drive cycle with no new codes before the test.